How to Properly Terminate an unused OP-Amp to Avoid Noise and Power Related Issues
Is it okay to leave IC pins unused? (powerbank schematic) : r/ElectricalEngineering
Already ordered the PCB for my project but forogot to tie unused pins to ground on one of the ICs. Came up with this solution. Imrpovise. Adapt. Overcome. : r/electronics
9. What to do with unused pins on an Atmega328P or Attiny85? - Tech Explorations
Is it OK to leave the unused inputs of general-purpose CMOS logic ICs open? | Toshiba Electronic Devices & Storage Corporation | Americas – United States
integrated circuit - Should NC-Pins of IC connected to ground through a resistor to prevent noise? - Electrical Engineering Stack Exchange
NC Pins in Integrated Circuits – SnapEDA Blog
Is it OK to leave the unused inputs of general-purpose CMOS logic ICs open? | Toshiba Electronic Devices & Storage Corporation | Americas – United States
Unused Pins | Analog Devices
DA9061/2 Unused Pin Configuration AN-PM-105
The Unused Op Amp—what to do? - The Signal - Archives - TI E2E support forums
What to do with Unused or 'No Connection' Pins? - FAQs - Engineering and Component Solution Forum - TechForum │ Digi-Key
NE572N Signetics IC 16 Pin Dip New and Unused 572N | eBay
PS2 KEYBOARD KEYLOGGER CIRCUIT ATMEL AT89C2051
Termination of unused pins for CY27410/CY27430 – K... - Infineon Developer Community
Two 28 Pin DIP IC Socket With Machined Gold Pins SO-0014 - Etsy
Where to connect unused pins operational amplifier - Electrical Engineering Stack Exchange
Ic & Component Sockets 28P Tin Pin Tin Cont 50 Pieces - SPW Industrial
What to do With Unused Pins on a Microcontroller | PCB Design Blog | Altium